Call Us for your best package
pricing and product availability.
OUR PART #: 36A123 MFR #: 36A123
Mic element foam pad for the Shure SM58 microphone ... Read more
Mic element foam pad for the Shure SM58 microphone.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
If you’re not confident in your diagnosis it may be best to take your item to a qualified technician.
If you’re concerned about the duration of a spare part warranty please contact us before placing your order. Be aware that if you install a part to repair an item that’s still under the manufacturer’s warranty you may void the warranty in your item by performing unauthorized repairs.
Parts appearance may vary from the original component depending on the manufacturer the vendor uses. Please be aware that we cannot be responsible for damages because of installation of an incorrect part. Unopened, uninstalled parts can be returned within 30 days.
There are no reviews to display with the selected filters.
This is the real deal for the transducer foam disc. On very old mics the old foam always turns to sonically bad goo. While you're at it, get a pile of the inner grill foam too.
Thank you for submitting your comment. It is in a queue to be moderated.
What I needed when I needed it. The only source I could readily find for this product.
Thank you for submitting your comment. It is in a queue to be moderated.
Just what I needed to update a clean SM58
Thank you for submitting your comment. It is in a queue to be moderated.
The foam pad for the mic element fits just fine. It is held in place only by slight friction against the plastic pins around the edge of the mic element cover. The pad stays in place, but could easily be knocked loose if the mic were to be bumped. It may have been the same way with the original pad. I don't know if the factory uses an adhesive.
Thank you for submitting your comment. It is in a queue to be moderated.
This reviewer left no comment.
Thank you for submitting your comment. It is in a queue to be moderated.
Perfect fit for replacement of the inner foam on top of the element on a Shrue SM 58
Thank you for submitting your comment. It is in a queue to be moderated.
As advertised
Thank you for submitting your comment. It is in a queue to be moderated.
This pad fit my mic perfectly. I own two Radio Shack high ball dynamic mics made by Shure. They are a copy of the sm58. I purchased them back in the 80's and the foam was completly descinagrated. This pad fit the top of the mic element perfectly. I had to mark and cut tiney slits around the edge for the raised fins on the top of the element. Then i glued it in place with foam edge surround repair glue i had left over from another project. I applied the glue with the tip of a tooth pic.
Thank you for submitting your comment. It is in a queue to be moderated.