Audix M60NP rofile Hemi-Cardioid Condenser Boundary Mic, Phoenix Connector, Nickel

From podiums speeches to board room meetings, M60N delivers top audio quality with sleek aesthetics. This miniaturized condenser microphone contains a terminal Phoenix connector, protection from RF interference, and fully integrated preamp circuitry—eliminating the need for a remote phantom power module. Designed with a brass housing and a shock absorbent bottom, the microphone is cardioid by design but can produce a hemi-cardioid polar pattern when coupled with a flat surface (such as a table or floor). Attached directly to the internal circuitry is a high quality 12 ft. shielded mic cable, able to exit the housing at 180° or 90° for maintaining quality while finding the best device positioning. Designed, assembled, and tested in the USA, M60N connects easily to a "mic level" input any console, mixer, or recording device with phantom power voltage (18-52 V). M60N is ideal for courtrooms, meeting rooms, and podium settings. 

Features

• Optimized for voice
• Immunity from RF interference
• Extremely high sensitivity
• Miniaturized integrated preamp circuitry
• Proprietary low noise circuitry

Specifications

• Connector: Terminal
• Transducer Type: Condenser
• Frequency Response: 70 Hz - 8 kHz
• Polar Pattern: Hemi Cardioid
• Output Impedance: 150 ohms
• Sensitivity: 68 mV / Pa @ 1k
• Equivalent Noise Level: 22 dB (A-weighted)
• Signal to Noise Ratio: 72 dB
• Maximum SPL: =130 dB
• Dynamic Range: 108 dB
• Power Requirements: 18-52 V phantom
• Connector: Phoenix
• Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
• Materials: Brass/ Black, Nickel Finish
• Weight: 8.3 oz
• Length: 2.48"