DPA MMP-ER/ES 3m (9.8') Modular Active Cable, Side- or Rear-Entry with XLR

DPA Microphones' MMP-ER/ES Modular Active Cable Preamplifier is designed for use with hanging mics as well as low-profile table or instrument mics that employ any of the modular capsules in their d:dicate™ Microphones Series. It comes with your choice of either rear-entry [ER version] or side-entry [ES version] cable design, and includes a high-quality preamplifier that's split into a 12mm housing on the one end, and output via a 3-pin XLR connector. This cable can then connect the capsule to a standard XLR mic cable (sold separately) for extension of lengths from 3 to 30 meters. The preamplifier is ultra-transparent, with active drive for impedance balancing for rejection of frequency interference.

Specifications

• Output connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Low-cut frequency, -3 dB: 15 Hz
• Noise with shorted input A-weighted: 0.6 µV
• Output voltage, RMS: 2.2 V
• Output voltage, peak: 3.1 V
• Type of electronic circuit: Active
• THD @1 VRMS, 1 kHz: < 0.2 %
• Dynamic range: 131 dB
• Output impedance: 100 Ω
• Minimum load impedance: 2 kΩ
• Cable drive capability: 100m (324ft)
• Output balance principle: Impedance-balancing
• Common mode rejection ratio (CMRR): > 40 dB
• Power supply (for full performance): 48 V Phantom power (± 4 V)
• Current consumption: 3.5 mA
• Color: Matte black
• Weight: 91 g (3.2 oz)
• Dimensions (Ø x L): 0.75" x 9.8ft (19mm x 3m)
• Temperature range: -40 °F to 113 °F (-40 °C to 45 °C)
• Relative humidity (RH): Up to 90 %