Product Overview
Intelligent performance meets digital sound reinforcement in one wireless kit.
ULXD Digital wireless systems from Shure offer uncompromising audio quality, RF signal stability, and advanced setup features in a compact 1U rack unit. True-to-the-source sound reproduction, ULXD4D-G50 Dual-Channel Digital Receiver (470-536MHz), offers scalable control in your permanent or installed sound system, 24-bit digital audio, wide frequency response, AES-256 encryption, and reliable RF protection from stray signal interference—even in conference environments. Streamline your workflow; ULXD is compatible with Wireless Workbench® 6, SystemOn, and ShurePlus™ Channel monitoring apps. This Dual Channel receiver also features Dante™ digital audio networking. Rugged, yet lightweight, the chassis houses independent audio and RF meters, gain control, and receiver outputs that can be direct or summed for flexible signal routing. Pairing with this unwavering receiver are two ULXD Wireless Bodypacks and two WL93 omnidirectional, subminiatures microphones. Durable and lightweight, transmitter features include visually unobtrusive attachment, acoustic windscreen, 4-pin mini connector, innovative RF performance, AES-256 bit encryption, and Proprietary Shure Gain Ranging to optimize dynamic range for any input source. Complete with optimal rechargeable Lithium-Ion batteries, this ULXD wireless kit is a paramount choice for clarity at conferences and convention centers.
Note: This product may only be shipped to destinations within the contiguous United States, in accordance with regulations for safe transportation of hazardous materials established by the U.S. Department of Transportation (DOT) and International Air Transport Association (IATA).
ULXD Dual-Channel Wireless Lavalier Kit Includes
- (1) ULXD4D-G50 ULX-D Series Dual-Channel Digital Wireless Mic Receiver, G50 Band (470-536MHz)
- (2) ULXD1-G50 ULX-D Series Digital Wireless Bodypack Transmitter, G50 Band (470-534MHz)
- (2) WL93 Omni Condenser Subminiature Lavalier Mic with 4' Cable And TA4F Connector, Black
- (2) SB900B Lithium-Ion Rechargeable Battery
- (1) SBC200-US Two-Bay Portable Battery Charger With Power Supply
Shure ULXD14D/93-G50 Features
- Operates in the G50 Band (470-536MHz)
- Smooth, extended frequency response in WL93 specially tailored for chest-worn operation
- Controlled low-frequency roll-off reduces low-frequency clothing and room noise
- Individual gain controls, LED meters, and XLR outputs for each channel on ULXD4D-G50 receiver
- Dante™ digital networked audio over Ethernet
- 8.5-hour battery life from one full charge on SB900B Lithium-Ion battery
Specifications
- WL93 Omni Condenser Subminiture Lavalier Mic Specifications
- Type: Condenser (electret bias)
- Frequency Response: 50 Hz - 20 kHz
- Polar Pattern: Omnidirectional, uniform with frequency
- lmpedance: 3 kΩ
- Output Level: Open Circuit Voltage: -38 dBV/Pa* (13 mV) *1 Pascal = 94 dB SPL
- ULXD1-G50 Digital Wireless Bodypack Transmitter Specifications:
- AUDIO INPUT:
- Connector: 4-Pin male mini connector (TA4M) Configuration: Unbalanced
- Impedance: 1 Megaohm
- Maximum Input Level, 1 kHz at 1% THD:
- Pad Off: 8.5 dBV (7.5 Vpp)
- Pad On: 20.5 dBV (30 Vpp)
- Preamplifier Equivalent Input Noise (EIN), System Gain Setting =+20 (120 dBV, A-weighted, typical)
- RF OUTPUT:
- Connector: SMA
- Antenna Type: 1/4 wave
- Impedance: 50 Ohms
- Occupied Bandwidth: < 200 kHz
- Modulation Type: Shure Proprietary Digital
- Power: 1 mW, 10 mW, 20 mW
- Audio Frequency Response: 20 Hz to 20 kHz (±1 dB), flat (Dependent on microphone type)
- Operating Range: 300 ft (100 m)
- Connector: 3-pin TQG
- Gain Offset Range: 0 to 21 dB (in 3 dB steps)
- Battery Type: Shure SB900 Rechargeable Li-Ion or AA batteries
- Dimensions (HxWxD): 3.4" x 2.6" x 0.9"
- Weight: 142 g (5.0 oz.), without batteries
- Housing: Cast aluminum
- ULXD4D-G50 Series Dual Channel Receiver Specifications:
- RF Carrier Frequency Range: 470–530 MHz
- RF Tuning Step Size: 25 kHz, varies by region
- Image Rejection: >70 dB, typical
- RF Sensitivity: −98 dBm at 10-5 BER
- AUDIO DYNAMIC RANGE: *A-weighted, typical, System Gain @ +10
- XLR Analog Output: > 120 dB
- Dante Digital Output: 130 dB
- Total Harmonic Distortion: −12 dBFS input, System Gain @ +10
- System Audio Polarity: Positive pressure on microphone diaphragm produces positive voltage on pin 2 (with respect to pin 3 of XLR output) and the tip of the 6.35 mm (1/4-inch) output.
- Dimensions: 44 x 482 x 274 mm
- Weight: ULXD4D 3.36 kg (7.4 lbs), without antennas
- Housing: steel; Extruded Aluminum
- Power Requirements: 100 to 240 V AC, 50-60 Hz, 0.26 A max.
- RF INPUT:
- Spurious Rejection: > 80 dB, typical
- Connector Type: BNC
- Impedance: 50 Ω
- Bias Voltage: 12 to 13 V DC, 150 mA maximum, per antenna
- CASCADE OUTPUT:
- Connector Type: BNC
- Configuration: Unbalanced, passive
- Impedance: 50 Ω
- Insertion Loss: 0 dB
- AUDIO OUTPUT
- Gain Adjustment Range: −18 to +42 dB in 1 dB steps (plus Mute setting)
- Impedance: 100 Ω
- FULL SCALE OUTPUT
- LINE setting: +18 dBV
- MIC setting: −12 dBV
- Mic/Line Switch: 30 dB pad
- Phantom Power Protection: Yes
- NETWORKING
- Network Interface: Dual Port Ethernet 10/100 Mbps, 1Gbps, Dante Digital Audio
- Network Addressing Capability: DHCP or Manual IP address
- Maximum Cable Length: 100 m (328 ft)
- SB900B Lithium Ion Rechargeable Battery Specifications
- Dimensions (HxLxD): 1.25" x 1.98" x 0.67" (31.8 x 50.4 x 17.5 mm)
- Charge Temperature: 0ºC to 45ºC (recommended)
- Constant Charge Voltage: 4.2V
- Constant Charge Current: 750 mAh
- Nominal Voltage: 3.7V
- Weight: 1.4 oz (39.7 g)
- Housing: Lexan
- Rated Capacity: 1450 mAh
- SBC200-US Two-Bay Portable Battery Charger Specifications
- Battery Type: Up to 2 rechargeable Li-Ion batteries (SB900)
- Charge Current: 0.75 A
- Charge Time: 50%=1 hour; 100%=3 hours
- Power Requirements: 15 V DC, 3.33 A max.
- Dimensions: 2.6" x 3.9" x 6.5"
- Weight: 10 oz
