Radial Engineering Reamp HP Reamper for Computer/Interface Headphone Outputs

The Reamp HP takes the signal from a headphone output jack on an audio interface or a mobile device and converts it to feed mono guitar amps and effects pedals for Reamping. Easily assign the track you want to Reamp to the right channel of your headphone output and you're ready to feed guitar, bass, or even vocal tracks through your amplifier to record or explore with new tones and settings. You can even assign stereo tracks to the Reamp HP and sum them down using the dedicated mono switch on the device.

Radial Engineering REAMP-HP Features:

• Play prerecorded tracks through amps and pedals
• Easily Reamp from any interface or playback device
• 1/4″ and 3.5mm inputs connect to a headphone output jack
• Transformer isolated for low-noise recordings

Radial Engineering REAMP-HP Specifications:

• Audio circuit type: Passive, transformer isolated
• Frequency response: 20Hz ~ 20KHz (+/- 0.5dB)
• Dynamic range: >96dB
• Total harmonic distortion: 0.0015% @1kHz
• Input Impedance: 11.8kΩ
• Output Impedance: 1.5kΩ
• Equivalent Input Noise: -105dBu
• Noise: -125dBu
• Maximum Input: >+20dBu
• Features: Mono Sum, Ground lift, Level Control
• Input Connectors: ¼" TRS unbalanced stereo, 3.5mm TRS unbalanced stereo: Yes
• Output Connectors: ¼" TS
• Construction: 16 gauge steel chassis and outer shell
• Size (L x W x D): 4.6" x 1.50" x 1.89" (117mm x 48mm x 38mm)
• Weight: 0.58 lbs
• Power: Passive, no power required
• Conditions: For use in dry locations only between 5°C and 40°C
• Warranty: Radial 3-year, transferable